Other Connectors - Shuttle MZ11 User Manual

Other Connectors

ATX Power Supply Connector - J2
It is a 20-pin male header connector is connected
to the ATX power supply. The plug of the power
supply will only insert in one orientation because of
the different hole shade and size. Find the proper
orientation and push down firmly making sure that
the pins are aligned.
Figure 3-9 shows ATX Power Supply Connector.
IR Connector - J16
If you have an Infrared device, this mainboard can
implement IR (Infrared) transfer and meet both
ASKIR and HPSIR specifications. To enable the
IR transfer function, follow these steps:
Step 1. Attach the 5-pin infrared device cable to
J16 connector. (Refer to the above diagram
for IR pin assignment.)
Step 2. Configure the Infrared transfer mode in the
UR2 Mode field of Integrated Peripherals
menu in BIOS Setup. This mainboard
supports IrDA 1.0, ASKIR, MIR 0.57M
and MIR 1.15M transfer modes. FIR is
not currently supported.
Enhanced IDE, Floppy and COM2
Connectors
The mainboard shipped with one 40-pin ribbon cable
for IDE H.D.D, one 34-pin ribbon cable for F.D.D.
and one 10-pin ribbon cable for COM2. Flat cables
should be connected with the red stripe on the pin 1
side of the connector.
Figure 3-12
- 16 -
Figure 3-9
Figure 3-10
Figure 3-11