Other Connectors; Atx Power Supply Connector (Atx1); Case Fan (Casfan1) - Shuttle MK32N User Manual

Other Connectors

F

ATX Power Supply Connector (ATX1)

E1
Locate the 20-pin male header ATX power connector (ATX1) on your
mainboard. Plug the power cable from the ATX power supply unit directly
into (PWR1) ATX power supply connector.
Note 1: The ATX power connector is directional and will not go in unless the
Note 2: Make sure the latch of the ATX power connector clicks into place to
Note 3: Your ATX power supply must be supplied to ACPI +5V standby power
Note 4: Make sure your power supply have enough power for higher speed
Cooling Fan Connectors for CPU (CPUFAN1) and Case (CASFAN1) Fan
E2
The mainboard provides three onboard 12V cooling fan power connectors
to support CPU (CPUFAN1) and Case (CASFAN1) cooling fans.
FAN1 with rotate sense.
FAN2 without rotate sense.
Note:
guides match perfectly making sure that pin#1 is properly positioned.
ensure a solid attachment.
and at least 720mA compatible.
processor installed.
SENSE +12V
Both cable wiring and type of plug may
vary depending on the fan maker. Keep
in mind that the red wire should always
be connected to the +12V header, and
the black wire, to the ground (GND)
header.
GND
1
- 38 -
CASFAN1
1
1