JUKI PS-800-12080 Instruction Manual page 83

❹
❷
Parallel
6-2-4-3. Position of the knife pressure adjust-
Adjust the position of the knife pressure adjustment
screw so that it does not protrude the end face of the
counter knife.
❶
6-2-4-4. Position of the knife pressure adjust-
❶
Temporarily tighten setscrew ❸ to allow the counter
knife to be pressed against two portions ❹ of mount-
ing base ❷ .
Loosen connection screw ❶ . Turn the counter knife
shaft by hand to adjust so that the counter knife is
almost in parallel with the moving knife.
❸
– 80 –
ment screw of the counter knife
ment screw of the counter knife
Under the operation panel manual mode,
press the "OUT1 (before the port change)
/ OUT9 (after the port change)" button to
place it in the ON state. Bring the moving
knife closer to the counter knife. Adjust
the parallelism between them.