JUKI PS-800-12080 Instruction Manual page 59

Error Error description
Code
E227 The file transfer failed
E228 Data outside the range
E229 The modified Angle is too
large
E230 Loading graph data...
E231 Foot follow error
E232 No U disk!
E233 File error!
E234 Graph or head offset out of
bounds!
E235 This is not a working file!
E236 TF RAM error
E237 Please set the admin pass-
word first
E238 Editing is not supported
E239 Please contact the manu-
facturer
E240 Communication fault 2
E241 Time anomaly
Fault Cause
1. The screen cable interface is
loose or disconnected
2. The screen or motherboard pro-
gram is too old
3. Screen or motherboard hardware
failure
4. The screen line is tied with a
strong interference source
The current graphic file data exceeds
the maximum format limit
Single modification of graph angle
value is too large
Processing necessary graphics data
1. The presser foot motor is stuck
when it rotates.
2. Parameter setting error
1. U disk is not inserted or damaged
2. The screen U disk interface is
damaged
An error occurred while reading or
writing from the USB flash drive
1. The file size is too large to exceed
the processable range
2. The file is small but offset from the
processable range
3. Head offset is out of bounds
4. The parameters are set incorrect-
ly, such as the size of the pressure
plate
File content or format error
Bad motherboard
No administrative password is set
No editing instructions or files
Contact the manufacturer
1. Bad communication or damage to
the screen leads to CAN commu-
nication failure
2. The screen or motherboard pro-
gram is too old
3. The screen or motherboard is
broken
Time is wrong
– 56 –
Solution
1. Check the screen line
2. Upgrade the latest screen or mother-
board program
3. Test whether you can upgrade the
motherboard program; test whether the
communication is normal in the "Test
Transmission" interface, and replace
the hardware if it is abnormal
4. Separate screen wires from strong
interference wires such as motor power
wires
Check if the graphic data is abnormal
Decrease the modified angle value
Wait for a while before proceeding
1. Check if the presser foot motor is nor-
mal
2. Reset parameters
1. Re insert U disk or replace U disk
2. Insert other U disk interface or change
screen
1. Replace graphics files
2. Re insert U disk or replace U disk
1. Replace graphics with smaller height
and width
2. Reset the reference point position
3.Reset the head offset value of head 2 or
head 3.
4. Set the platen size corresponding to the
machine
Replace Recognizable Graphics File
Replace the motherboard
Need to set an administrative password
first
No editing instructions or files
Contact equipment manufacturer
1. Check the screen line
2. Upgrade the latest screen or mother-
board program
3. Replace the screen or motherboard
1. The time is illegally modified
2. The motherboard battery is low.