JUKI PS-800-12080 Instruction Manual page 39

❼
8) Placing the material to be sewn
1. Detaching the pattern
When you move the pattern to the reset position and press clamp button ❹ on the operation panel, two air
cylinders on the X-direction linear module release the pattern. Take out the pattern.
2. Placing the material
Place the material to be sewn on the pattern. Then, check that the material is neatly arranged horizontally.
In addition, secure the material with the holding method that matches the pattern to prevent the material
from moving out of position. If the material has an infill of feather or cotton, squeeze the material to push
out air as far as possible.
9) Setting the reset, pattern on which the material is placed, and the reference
* Carry out resetting following the step of procedure 3).
* Handling of the pattern on which the material is placed is described in the step of procedure 5).
* Reference setting is carried out following the step of procedure 7).
10) Starting
Press the start button ❻ on the operation panel to start sewing. Then, the sewing machine enters the
automatic sewing mode.
11) Temporary stop
If any accident occurs during sewing, press the temporary stop button ❼ on the operation panel. Then,
the sewing machine immediately stops operation.
12) Re-starting
Once the aforementioned accident is eliminated, turn temporary stop button ❼ . Then, the button pops
up and the emergency stop mode is reset. Then, press start button ❻ to re-start automatic sewing.
❺
❹ ❻
– 36 –
7) Selecting the reference
In order to align the locus of sewing pattern with
the sewing slits of the pattern, it is necessary to
set a reference. Specifically, set the reference re-
ferring to the Instruction Manual for the electrical
system scanner.
After the completion of establishment of a refer-
ence, display the operation screen. When you
keep button ❺ held pressed, the pattern locus
simulation sewing starts.
Operate the sewing machine once to check
whether or not the sewing pattern locus is aligned
with the pattern slits. If they are not aligned,
re-adjust the reference.
To stop the operation while the simulation opera-
tion is being carried out, press button ❼ to stop it.