JUKI PS-800-12080 Instruction Manual page 67

No. Region
Lubricate two Y-direction linear guide
4
sliders through their four oil holes.
Apply oil to two oil holes of the X-di-
5
rection linear guide sliders.
1. Aligning needle tip ❶ with Y-di-
rection linear guides ❷ , ❸ , ❹
and ❺ , squeeze the syringe
to add oil to the oil hole of the
❶ ❶
respective linear guides.
❷ ❷
2. Lubricate each portions requir-
ing lubrication at least five times.
The oil amount for each portion
should not fall below 5cm
3. Every time the grease is applied
through the oil hole, press the
❸ ❸
slider on the linear guide several
times to spread the grease over
❶ ❶
the clearance between balls.
❹ ❹
4. After a sufficient amount of
grease is added, check to make
sure that the grease exudes
between the ball screw and the
nut.
5. Lithium based grease No. 2
should be used as lubricating
grease. Do not use it with mixed
❺ ❺
with other type of lubricating
grease.
1. Aligning the tip of syringe with
oil holes ❶ and ❷ , squeeze the
syringe to respectively add oil
through oil holes ❶ and ❷ until
oil they are filled with oil once.
2. Lubricate each portions requir-
ing lubrication at least five times.
❷ ❷
The oil amount for each portion
❶ ❶
should not fall below 5cm
3. Every time the grease is added
through the oil hole, press the
slider on the linear guide sev-
eral times to spread the grease
sufficiently over the clearance
between balls.
4. After a sufficient amount of
grease is added, check to make
sure that the grease exudes
between the linear guide and the
slider.
5. Lithium based grease No. 2
should be used as lubricating
grease. Do not use it with mixed
with other type of lubricating
grease.
Explanation
3
3
– 64 –
Operating time
1. Replenish the ma-
chine with lubricating
grease again after
the equipment has
run 6400 km or for
five years.
2. According to the envi-
ronment of usage,
. apply the lubricating
grease once every
three months or when
the sewing machine
has sewn 100 million
stitches after the first
lubrication.
1. Replenish the ma-
chine with lubricating
grease again after
the equipment has
run 6400 km or for
five years.
2. According to the envi-
ronment of usage,
. apply the lubricating
grease once every
three months or when
the sewing machine
has sewn 100 million
stitches after the first
lubrication.