JUKI PS-800-12080 Instruction Manual page 46

Classifica-
tion of pa- No. Parameter name
rameters
Reset P39 Return-to-origin speed
setting (mm/min)
P756- Output I/O setting be-
P761 fore resetting
P762-
P797
P649 Alarm in the case of a
resetting error
P782- Output IO setting after
resetting
P787
P788-
P793
Setting of P40 Automatic thread trim-
ming during temporary
stop
stop
P41 Needle position during
temporary stop
P45 Temporary stop switch
type
P799 Presser foot is not lifted
during temporary stop
Statistics P49 Bobbin thread remain-
ing amount is cleared at
settings
the time of turning the
power ON
P50 Operation stops after
the bobbin thread has
run out
P51 Bobbin thread counter
setting is enabled
P46 Bobbin thread counter
is cleared at the time of
turning the power ON
P47 Operation continues
after the counter has
reached the set value
P48 Counter setting is en-
abled
P52 Working hours counter
P779 Bobbin thread count
mode
P780 Adjustment value of
the surplus amount of
bobbin thread (mm)
Standard
Range
value
100 to 60000 15000
OUT1 to OUT6 / Not set
Not set
High level / low High level
level
Yes/No No
OUT1 to OUT6 / Not set
Not set
High level / low Low level
level
Yes/No Yes
Upper stop posi- Upper
tion / Lower stop stop posi-
position tion
Self lock / Normal Self lock
Yes/No No
Yes/No No
Yes/No Yes
Yes/No Yes
Yes/No Yes
Yes/No Yes
Yes/No Yes
Yes/No Yes
IN1 to IN4 / de- Default
fault
0 to 600000 0
– 43 –
Meaning of parameter and comment
x, y axes speed during resetting to the
origin
Setting of IO before resetting
Setting of IO after returning to the origin
Whether automatic thread trimming is
performed at temporary stop
Needle bar position when temporary
stop
Soft type of temporary stop, self-lock-
ing and normal
"Normal" automatically bounces when
touched
Whether the remaining amount of
bobbin thread is reset to 0 (zero) when
turning the power ON
In the case of "Yes", the sewing ma-
chine stops when the consumed bobbin
thread length has reached the "entire
length".
In the case of "Yes", statistics automat-
ically indicate the consumed bobbin
thread length
Whether the sewing counter is reset to
0 (zero) when turning the power ON
Whether the operation is continued after
the sewing counter has reached the set
value
Whether the sewing counter is enabled
In the case of "Yes", the machining time
statistics function is enabled
Statics mode of the bobbin thread
amount
Adjustment of the bobbin thread remain-
ing amount