Preparation For Sewing - JUKI PS-800-12080 Instruction Manual

4-21. Preparation for sewing

❷ ❷
❸
S type
B B B B
A A
H type
B B
6) Reading the sewing pattern data
1. In the case an IC card is attached to the pattern, activate the electronic scanner on the operation screen
(refer to the Instruction Manual for the electrical system).
The electrical system automatically identifies the sewing pattern program that matches the pattern from
those stored on the IC card
2. In the case no IC card is attached to the pattern, manually select the sewing pattern data that matches
the relevant pattern on the operation screen.
❶ ❶
B B B B
A A
A A B B
1) Turning ON the main power switch.
Press button ❶ to turn ON the main power switch.
2) Turning ON the main air source switch
Move main air valve ❷ to the right to open the
main air source.
3) Resetting the equipment
When the equipment is reset by pressing
❸ , the needle stops at its upper stop position,
and the disk presser and intermediate presser go
up.
4) Read the pattern data to be sewn, or directly edit
the pattern data on the operation panel.
Refer to the Instruction Manual for the comput-
er-control system for details.
5) Attaching a pattern
Moving an empty pattern (with no material), fit
positioning hole A on the pattern positioning
plate on the positioning pin. Fit other two auxiliary
positioning holes B on the positioning sleeves
and fully push them until they will go no further.
– 35 –