JUKI PS-800-12080 Instruction Manual page 48

Classifica-
tion of pa- No. Parameter name
rameters
Other P74 Whether or not the air
settings pressure detection is
required
P75 Whether or not the
repetitive operation is
required
P76 Repetitive machining
time (min)
P77 Repetitive machining
interval (s)
Other P78 Work ending position
settings
P395 Template recognition
method
P81 Interface style
P681 Motion mode is started
before operation
P755 Jump mode during op-
eration
P241 Connection to the ex-
tended screen
P79 Reverse feed after main
shaft needle stops
P242 Voice prompt
P21 Enabling the memory
function during power
failure
P194 The file is enabled upon
separation of the elec-
tronic label
Standard
Range
value
Yes/No No
Yes/No No
1 to 65535 1440
0 to 20 2
Return to 0 (zero) Return to
/ sewing starting 0 (zero)
position / default
Barcode / elec- Electronic
tronic tag tag
Classic / simple Classic
XY simultaneous / XY simul-
X precedence / Y taneous
precedence
X precedence / Y X prece-
precedence / XY dence
simultaneous
Yes/No No
0 to 160 0
High / medium / OFF
low / OFF
Enable / disable Enable
Enable / disable Disable
– 45 –
Meaning of parameter and comment
In the case of "Yes", the sewing ma-
chine stops and generates the alarm if
the detected air pressure is low during
work
"Yes" means that cyclic machining of
the same file is started after turning the
power ON
Cyclic machining total time: When the
set time has elapsed, cyclic machining
is stopped
Interval from the completion of machin-
ing to re-starting of machining under the
cyclic machining mode
Return to 0 (zero): All of x / y axes
coordinates return to 0 (zero); sewing
machine terminates sewing; reset point
Right side: Rightmost position within the
machining range
Sewing starting position: First sewing
point of the machining file
Default: The sewing machine stops after
the completion of machining
By serial number of file: Barcode identi-
fication mode
By file name: Electronic tag identifica-
tion mode
Classic: Button style of the virtual body
Simple: Flat button style
Jump travel mode
In the case of "Use", information on the
operation file can be displayed on the
external add-on display
"High", "medium" and "low" respectively
refer to the magnitude of sound
After re-energization of the sewing
machine, the sewing sequence carried
out before power failure is resumed to
continue sewing from that interrupted
sequence.