JUKI PS-800-12080 Instruction Manual page 47

Classifica-
tion of pa- No. Parameter name
rameters
Thread P54 Thread clamp position
clamp set- at the beginning of sew-
ing
ting
P236 Laser output IO
P693 Enabling automatically
changeable hook
Detection P55 Automatic detection of
thread breakage
of thread
breakage
P56 Neglect of detection of
thread breakage
P57 Detection is ignored for
the set number of stitch-
es during sewing
P58 Detection of the effec-
tive number of stitches
in the case of thread
breakage
P237 Thread breakage output
IO
Thread P60 The number of revo-
breakage lutions of the thread
trimmer main shaft (r/
setting
min)
P61 Delay in the start of
thread trimmer (s)
P62 Continuous operating
time of the wiper (s)
P63 Delay in the lifting of
presser foot after turn-
ing OFF the wiper (s)
P65 Whether or not the
thread is trimmed during
jump after sewing
P66 Whether or not the wip-
er is used
P169 Thread slackening start
mode
P168 Thread slackening an-
gle
Energi- P70 The sewing machine
is returned to the "stop
zation
with its needle up" state
setting
at the time of turning the
power ON
P71 Clamp is automatically
returned to its origin at
the time of turning the
power ON
P73 Presser foot is lifted at
the time of turning the
power ON
Standard
Range
value
0 to 200 0
Yes/No No
Yes/No No
Yes/No Yes
Yes/No Yes
1 to 255 3
1 to 255 2
Yes/No No
10 to 2000 260
0.01 to 6.55 0.01
0.01 to 6.55 0.15
0.01 to 6.55 0.25
Yes/No Yes
Yes/No Yes
Angle / delay Angle
0 to 999 850
Yes/No Yes
Yes/No No
Yes/No Yes
– 44 –
Meaning of parameter and comment
Thread clamp position at the beginning
of sewing
Laser output
In the case of "Yes", the operation is
stopped and the description of error is
displayed.
Thread breakage detection function
In the case of "Yes", thread trimming is
automatically carried out after detection
thread breakage
Thread breakage is followed by thread
trimming
For the number of stitches firstly set,
thread breakage will not be detected
In the case thread breakage is detect-
ed continuously to reach the specified
maximum number of broken stitches,
it is assumed that thread has broken
definitely.
Thread trimmer main shaft speed
Delay time at the start of thread trim-
ming
Wiper operating time
Wiper OFF delay time
Whether thread is trimmed at the time of
jump
Whether the wiper is used
Starting timing method for turning OFF
the thread tension release mechanism
Thread tension release mechanism
turning-OFF angle
Needle bar is at upper position when
turning the power ON
Cassette automatically returns to its
origin when turning the power ON
Presser foot goes up when turning the
power ON