Table of Contents
Advertisement
5) Lift the upper radome until spring clamp contacts
the radome base flange.
7) Check antenna orientation. If the antenna is facing at horizontal direction, then rotate the antenna to a
counter weight down to face up around at 90 degrees (upward).
8) Lift up the upper radome until the M10 nut contacts
radome base flange.
6) Remove spring clamp from the bottom radome
and reattach it at top of the flange.
Counter
weight
9) Fasten the spring clamp above the
29
base flange.
M10 bolt
Spring clamp
M10 nut
Advertisement
Table of Contents
