Table of Contents
Advertisement
2) Remove
internal
unit from the base of radome by completely removing M8 bolts and M16 bolt set.
The
internal
unit will get damaged if placed directly on the floor without removing the M16 bolts. It
may also damage them if placed on the floor with M16 high nut loosened.
3) Mount 4 handles in the
when lifting unit. [Note: Turn too much handles may damage radome
4) Hold handles to lift up the
Beware the antenna feed arm can easy to damage or break.
Any deformation of the antenna arm can cause functional
issues and degrade antenna performance.
5)
Follow the steps 1 to 4 in the reverse order to reinstate equipment to the original configuration.
Beware to the following points:
- Do not remove handles during step 3).
- M16 high nut should be tightened in step 2).
It may damage the internal unit if M16 high nut is not tightened when reinstalled.
- Do not damage the antenna feed arm when covering the radome in step 1).
M16 high nut
internal
unit. Insert the handles until it hits to the bottom
internal
unit.
Attention point
22
for not to come off
base]
4 pcs of handles
Advertisement
Table of Contents
