Xtreme Manufacturing XR630 Operation And Safety Manual page 60

XR630
4. Raise the boom until pivot pins (A) have seated fully in at-
tachment hooks (B).
Fig 80. Raise Boom Until Pivot Pins (A) Are Fully Seated in Attachment
Hooks (B)
5. Tilt the attachment up slightly. The quick attach adapter
should be tight against the rear of the attachment. Align the
holes between the quick attach adapter and attachment.
6. Insert pin completely through the attachment and quick
attach adapter.
Fig 81. Insert Quick Attach Pin Through Attachment and Quick Attach
Adapter
7. Insert quick attach pin keeper.
Operation Manual
Fig 82. Quick Attach Pin Keeper
Hydraulic attachments have a maximum
hydraulic pressure rating. Failure to make
sure the attachment is equipped with a
pressure reducing valve, or is rated to be
equal or greater than 3,200 psi (220.6 bar),
which is the maximum pressure of the Telehandler auxiliary
hydraulic system at the quick-disconnect couplers, could
result in death or serious injury.
8. Connect the quick attach couplers (this only applies to at-
tachments with a quick attach hydraulic system).
Fig 83. Quick Attach Couplers
60
Operation
Warning