Xtreme Manufacturing XR630 Operation And Safety Manual page 67

After Every 250 Hours of Operation
Comply with 50-Hour Maintenance Requirements
Change engine oil and filter
Check air filter (replace if necessary)
Check tension and condition of drive belts (use
tension meter to check belt tension)
Lubricate front and rear drive shaft grease fittings
Lubricate rear axle grease fittings
Inspect slide blocks for condition and tightness
Lubricate slide block contact areas
After Every Month or 300 Hours of Operation
Top off axle wheel-end and differential oil
After Every 500 Hours of Operation
Comply with 50-Hour Maintenance Requirements
Comply with 250-Hour Maintenance Requirements
Replace air filter
Replace fuel filter
Empty air filter dust cup
Check engine hoses and connections for leaks,
damage, and tightness
Check radiator hoses for leaks, damage, and tightness
Check electrical cables, leads, and connections for
damage and tightness
Check specific gravity of engine coolant
Replace hydraulic reservoir air breather
Replace hydraulic return line filter
Replace hydraulic high-pressure filter
Replace hydraulic filter on drive pump
After Every 1,000 Hours of Operation
Comply with 50-Hour Maintenance Requirements
Comply with 250-Hour Maintenance Requirements
Comply with 500-Hour Maintenance Requirements
Change axle wheel-end and differential oil & clean
magnetic drain plugs
After Every 2,000 Hours of Operation
Comply with 50-Hour Maintenance Requirements
Comply with 250-Hour Maintenance Requirements
Comply with 500-Hour Maintenance Requirements
Comply with 1000-Hour Maintenance Requirements
Change hydraulic fluid
After Every 4,000 Hours of Operation
Drain and flush cooling system
Clean or replace hydraulic reservoir strainer
67
XR630
Operation Manual