Telehandler Travel; Steering Modes - Xtreme Manufacturing XR630 Operation And Safety Manual

Table of Contents

Advertisement

XR630

Telehandler Travel

Steering Modes

Never use crab or four wheel (4W) steering for
traveling at high speeds. Use only two wheel
(2W) steering for higher speed travel and
slow the Telehandler before turning. Rapid
turning using crab or four wheel (4W) steer-
ing could cause tip over, which could result in death, serious
injury, or property damage.
Check the turning radius around the Telehandler before
making a turn, especially if using four wheel (4W) steering,
which provides a tighter turning radius. Look over your
shoulder in the direction of the turn when backing. Failure
to remain aware of your turning radius area could result in
death, serious injury, or equipment damage.
DO NOT change steering modes until the Telehandler comes
to a complete stop.
The Telehandler includes three STANDARD modes of steering;
Crab, Two Wheel (2W), and Four Wheel (4W) Steering. Use the
Steering Select switch located on the dash panel to change
steering modes.
Crab Steering
Crab steering allows all four (4) wheels to turn
in the same direction as the steering wheel,
allowing the Telehandler to move "sideways".
Crab steering is useful in a congested work site
to line up to a loading location.
Operation Manual
Warning
Caution
Two Wheel Front Steering (2W)
Two wheel (2W) steering allows the front
wheels to turn in the same direction as the
steering wheel. The rear wheels remain in
a fixed forward position.
steering is useful for traveling at higher speeds.
Four Wheel Steering (4W)
Four wheel (4W) steering allows the front
wheels to turn in the same direction and the
rear wheels to turn in the opposite direction
of the steering wheel. The rear wheels follow
the front wheel path. Four wheel (4W) steering
is useful for a short turning radius and in muddy or sandy
conditions.
Allow for adequate clearance between the
attachment and other objects when turning.
The attachment extends beyond the front of
the Telehandler. The operator must be aware
of the maximum sweep of any attachment
being used, when turning, to avoid hitting personnel and
other objects in the area to prevent death, serious injury, or
property damage.
Fig 72. Maximum Fork Sweep
54
Operation
Two wheel (2W)
Warning

Advertisement

Table of Contents
loading

Table of Contents