Table of Contents
Advertisement
XR630
Before Starting Telehandler
Failure to use proper safety procedures when mounting
and dismounting the Telehandler could result in death or
serious injury.
•
Keep steps clear of dirt, mud, snow, ice, debris, and oth-
er hazards.
Face the Telehandler for mounting or dis-
mounting. Use hand holds and steps to main-
tain three (3) points of contact at all times,
either both hands and one foot or both feet
and one hand.
•
DO NOT use the controls, steering wheel, or foot pedals
as hand holds or steps. Avoid accidentally engaging or
disengaging a control.
DO NOT jump from the Telehandler. Clothing
can get caught on pedals, levers, or other
protruding parts. Landing on uneven surfaces
could result in death or serious personal
injury.
Before starting the Telehandler:
1.
Make sure the master battery disconnect is ON.
Fig 69. Battery Disconnect Switch ON to Start The Telehandler
2.
Turn the Fuel Shut-off valve ON.
3.
Use safe mounting/dismounting procedures to enter the
operator cab.
4.
Adjust the operator seat for position and comfort. (Refer
to Seat Adjustment section in this manual).
Operation Manual
Warning
Fig 70. Fuel Shut-off Valve Must Be ON to Start the Telehandler
5.
Adjust mirrors (this may require assistance).
6.
Fasten seat belt.
7.
Make sure the travel select lever is set to NEUTRAL (N)
8.
The Parking Brake MUST be engaged. Make sure that the
Parking Brake switch (A) is ON (DOWN). The parking brake
indicator (B) illuminates when the parking brake is set to
ON (engaged).
NOTE: The engine will only start when the travel select lever is
in NEUTRAL (N) and the Parking Brake switch is ON (engaged).
B
Fig 71. Travel Select Lever Must Be in NEUTRAL (N) AND Parking Brake
Switch (A) Must Be ON (Engaged) to Start the Telehandler.
52
Operation
A
Advertisement
Table of Contents
