Table of Contents
Advertisement
56
www.aeg.com
Problem
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance does not re-
tain the water drawer after
you insert it.
Water comes out of the wa-
ter drawer after you carry it
or put it inside the appli-
ance.
Water comes out of the wa-
ter drawer after you carry it
or put it inside the appli-
ance.
The appliance does not re-
tain the water drawer after
you push it on the cover.
The water drawer is difficult
to clean.
The descaling procedure is
interrupted before it finishes.
The descaling procedure is
interrupted before it finishes.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
Possible cause
There is an electrical fault.
You left the dish in the oven
for too long.
You did not assemble the lid
of the water drawer correct-
ly.
You did not assemble the lid
of the water drawer correct-
ly.
You did not assemble the
wave-breaker correctly.
You did not fully press the
water drawer body.
You did not remove the lid
and the wave-breaker.
There was a power cut.
The function was stopped by
the user.
You did not fill the water
drawer to the maximum lev-
el.
The grill- / roasting pan is on
a wrong shelf position.
Remedy
• Turn off the oven with the
house fuse or the safety
switch in the fuse box
and turn it on again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Assemble the lid of the wa-
ter drawer correctly.
Assemble the lid of the wa-
ter drawer correctly.
Assemble the wave-breaker
in the body of the water
drawer correctly.
Insert the water drawer body
in the appliance by pushing
it until it reaches to the end.
Refer to "Cleaning the water
drawer".
Repeat the procedure.
Repeat the procedure.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roasting
pan on the first shelf posi-
tion.
Advertisement
Table of Contents
