Advertisement
W10
W9
14. Press the remaining W10 part into place on the
RIGHT side of the wing. Be careful when pressing it
onto the spars. Use one of your fingers on the
bottom of the spar to keep from breaking it when
installing the wing tip. When happy with the fit and
you are sure that it is full seated against the ribs
and leading edge, glue it in place with thin CA.
15. Sand the leading edge at the wing tips to match the
profile shown on the plan sheet. Sand the leading
edge of the wing to the shape as shown on the plan
sheet.
12. Press the W9 leading edge onto W3 and fully up against
the ribs. Do NOT glue.
13. After making SURE that all the parts are fully seated
against each other and aligned with the plans, and holding
the parts down FLAT (small weights are great for this),
secure all the joints with thin CA.
Advertisement
