Advertisement
W2
W1
W9
4. Press the W9 leading edge onto W3 and fully up
against the ribs. Do NOT glue.
5. After making SURE that all the parts are fully
seated against each other and aligned with the
plans, and holding the parts down FLAT (small
weights are great for this), secure all the joints
with thin CA.
W5
W5
W4
W3
1. Slide the 4 ea. W5 ribs, W6 rib, and W7 rib onto the LEFT side of the spars, W1 and W2. Be
careful with W6 and W7 since the spars do not rest on your table there. Use a finger on the
bottom of the spars when pressing these ribs in place. Do NOT glue them in place yet.
2. Press the ribs into the W4 trailing edge part. Do NOT glue.
3. Press the ribs into the W3 leading edge support part. Do NOT glue.
6. Press the wing tip W10a/W10b parts together and glue with thin CA.
7. Press one W10 part into place on the left side of the wing. Be careful
W5
Do this to make 2 wing tips.
when pressing it onto the spars. Use one of your fingers on the bottom
of the spar to keep from breaking it when installing the wing tip. When
happy with the fit and you are sure that it is full seated against the
ribs and leading edge, glue it in place with thin CA.
W5
W6
W10
W7
Advertisement
