Cleaning The Wash Arm; Complete Cleaning; Protection Against Frost Damage - Hanseatic WQP8-J7736E User Manual

Page EN-22 Care and maintenance

Cleaning the wash arm

The nozzles in the wash arm may calcify or
become dirty due to food scraps. Check the
nozzles regularly and clean them if required.
1. Empty both racks and remove the lower
rack.
2. Pull the lower wash arm up and off.
3. The upper wash arm is attached by
means of a bayonet fitting. To remove the
wash arm, hold the two serrated bayo-
net grips (32) still and turn the wash arm
clockwise.
4. Clean the nozzles under running water.
5. Affix the spraying arm again after clean-
ing.
The wash arm must be firmly affixed and
must be able to rotate freely.

Complete cleaning

In well-stocked supermarkets and drugstores,
you will find special dishwasher cleaning
products. Cleaning the appliance using these
products takes place when the dishwasher is
empty and is very intensive. You should clean
the dishwasher in this way from time to time.
When doing so, please note the manufactur-
er instructions on the packaging.
Protection against frost
damage
Position the dishwasher in a room which is
protected from frost, if possible. If this is not
possible, protect the dishwasher against frost
as follows. You will need a shallow dish or a
(32)
pan, and a sponge.
1. Disconnect the mains plug from the sock-
et or switch off the fuse.
2. Close the tap and unscrew the inlet hose
(30).
3. Let the water from the inlet hose flow
completely into the dish.
4. Remove the (26) filters.
5. Remove the water from the sump floor
with the help of a sponge.