Securam ProLogic L22 Operation Instructions Manual page 9

ProLogic L22
After this initial power up it will also check to ensure that the system is communicating correctly. The
display will read "Link with Lock OK".
If the Display reads: "Fail to Link with Lock" proceed to Section 1.2 entitled "Pairing the EntryPad and
the Lock"
3.1 Opening the Lock
The safe lock system has two default codes installed as follows:
Super Code (ID00) 1-1-1-1-1-1
•
Manager Code (ID01) 1-2-3-4-5-6
•
Step 1: Enter a valid code – for example ID00.
The display will read "ID00 Verified".
And the Lock will open.
The display will read:
The lock will relock after 6 seconds.
Note: Time to relock is hard coded and cannot be changed.
3.2 Opening Lock with Time Delay Programmed
When Time Delay has been programmed, the user must enter a valid code.
Note: Users are defined as ID03- ID30
Wait through the preprogrammed time delay period, then enter the code again to open the lock safe, as
follows:
Step1: Enter a valid code
Note: ID00, ID01 and ID02 are Administrator users and will bypass Time Delay.
Operation Instructions
ID00
9