Table of Contents
Advertisement
■
Manual equalizer adjustment
1
Set "Parametric EQ" to "Manual" and press ENTER.
2
Press ENTER again to enter the edit screen.
3
Use the cursor keys to select a speaker and press ENTER.
X
• To restore the default settings for all speakers, select "PEQ Data Clear" and then "OK".
• To copy the parametric equalizer values acquired with "YPAO" (p.54) to the "Manual" fields for fine
adjustment, select "PEQ Data Copy" and then an equalizer type.
4
Use the cursor keys to select a center frequency from the 7 preset bands (4 for subwoofer).
5
To fine-adjust the center frequency, Q factor (bandwidth) or gain, use the cursor keys to select
an item.
Freq.: Use the cursor keys to adjust the center frequency of the selected band.
Q: Use the cursor keys to adjust the Q factor (bandwidth) of the selected band.
Gain: Use the cursor keys to adjust the gain of the selected band.
Setting range
Center frequency: 15.6 Hz to 16.0 kHz (15.6 Hz to 250.0 Hz for subwoofer)
Q factor: 0.500 to 10.080
Gain: -20.0 dB to +6.0 dB
6
To exit from the menu, press SETUP.
■
Test Tone
Enables/disables the test tone output. Test tone output helps you to adjust the speaker
balance or equalizer while confirming its effect.
Settings
Off
Does not output test tones.
Outputs test tones automatically when you adjust the speaker balance or
On
equalizer.
■
YPAO Result
You can check the previous YPAO adjustments ("Wiring", "Size", "Distance", "Level", "Angle
(horizontal)" and "Height") in "YPAO Result".
When the speaker settings you have configured manually are not suitable, you can discard the
manual settings and reload the previous YPAO adjustments.
Reloading the previous YPAO adjustments
1
Use the cursor keys to select "Setup Reload".
2
Press ENTER.
3
Press SETUP.
132
En
Advertisement
Table of Contents
