Installation; Wiring Requirements - Winmate W07FA3S-PCO1AC-POE Quick Start Up Manual

INSTALLATION

Wiring Requirements

The following common safety precautions should be observed before
installing any electronic device:
 Strive to use separate, non-intersecting paths to route power
and networking wires. If power wiring and device wiring paths
must cross make sure the wires are perpendicular at the
intersection point.
 Keep the wires separated according to interface. The rule of
thumb is that wiring that shares similar electrical characteristics
may be bundled together.
 Do not bundle input wiring with output wiring. Keep them
separate.
 When necessary, it is strongly advised that you label wiring to
all devices in the system.
CAUTION
 Do not run signal or communication wiring and power wiring in
the same conduit. To avoid interference, wires with different
signal characteristics (i.e., different interfaces) should be routed
separately.
 Be sure to disconnect the power cord before installing and/or
wiring your device.
 Verify the maximum possible current for each wire gauge,
especially for the power cords. Observe all electrical codes
dictating the maximum current allowable for each wire gauge.
 If the current goes above the maximum ratings, the wiring could
overheat, causing serious damage to your equipment.
 Be careful when handling the unit. When the unit is plugged in,
the internal components generate a lot of heat which may leave
the outer casing too hot to touch.
- 12 -