YASKAWA E7N Technical Manual page 262

Broadcast Data
The following table shows the broadcast data. Broadcast data can be written to.
Register
Address
0001H
0002H
Note: Bit signals not defined in the broadcast operation signals use local node data signals continuously.
Enter Command
When writing parameters to the Drive from the PLC using Modbus communication, the parameters are temporarily stored in
the constant data area in the Drive. To enable these parameters in the parameter data area, use the Enter command.
There are two types of Enter commands:
1. Enter commands that enable parameter data in RAM
2. Enter commands that write data to EEPROM (non-volatile memory) in the Drive at the same time as enabling data in RAM.
The following table shows the Enter command data. Enter command data can only be written.
The Enter command is enabled by writing 0 to register number 0900H or 0901H.
Register No.
0900H
0910H
The maximum number of times you can write to EEPROM using the Drive is 100,000. Do not frequently
execute Enter commands (0900H) written to EEPROM.
IMPORTANT
The Enter command registers are write-only. Consequently, if reading these registers, the register address
will become invalid (Error code: 02H).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table D.6 Broadcast Data
Operation signal
Bit 0 Run command 1: Operating 0: Stopped
Bit 1 Reverse operation command 1: Reverse 0: Forward
Bits 2 and 3 Not used
Bit 4 External error 1: Fault (set using H1-01)
Bit 5 Error Fault 1: Reset command (set using H1-02)
Bits 6 to B Not used
Bit C Multi-function digital input terminal S5 input
Bit D Multi-function digital input terminal S6 input
Bit E Multi-function digital input terminal S7 input
Bit F Not used.
Frequency reference 30000/100%
Table D.7 Enter Command
Write parameter data to EEPROM
Parameter data is not written to EEPROM, but refreshed in RAM only.
Communications D - 13
Contents
Contents