Power Failure - D-Link DES-3208 User Manual

10/100 Fast Ethernet Switch User's Guide
automatically and may be turned on without having any or all
LAN segment cables connected.
After the power switch is turned on, the LED indicators should
respond as follows:
All LED indicators will momentarily blink. This blinking of
the LED indicators represents a reset of the system.
The FDX/Col LED indicators blink from yellow to green.
The power LED indicator will light yellow while the switch
loads onboard software and performs a self-test. After
approximately 20 seconds, the LED will light green to
indicate the switch is in a ready state.
The console LED indicator will remain ON if there is a
connection at the RS-232 port, otherwise this LED indicator
is OFF.
The MII LED indicator will remain ON if there is a
connection at the MII port, otherwise this LED indicator is
OFF. If there is an active connection at the MII port, The
MII LED, and the 100M and Link/Act LED indicators for
port 2x will remain ON, otherwise the Link/Act LED
indicators are OFF. The 100M LED indicator may remain
ON or OFF depending on the transmission speed.
The System Load LED indicators will momentarily blink.

Power Failure

As a precaution, the Switch should be turned OFF in case of
power failure. When power is resumed, turn the Switch ON. At
all times, avoid leaving the Switch ON after the occurrence of a
power failure.
10
Unpacking and Setup