Table of Contents
Advertisement
10/100 Fast Ethernet Switch User's Guide
Designated Port: This is the port on each Designated
Bridge that is attached to the LAN segment for which the
Switch is the Designated Bridge.
Port Priority: The smaller this number, the higher the
Port Priority is. With higher Port Priority, the higher the
probability that the port will be selected as the Root Port.
Path Cost: This is a changeable parameter and may be
modified according to the STA specification. The 100Mbps
segment has an assigned Path Cost of 10, and each 10Mbps
segment has an assigned Path Cost of 100, based on the
STA specifications.
User-Changeable Parameters
The factory default setting should cover the majority of
installations. However, it is advisable to keep the default settings
as set at the factory; unless, it is absolutely necessary. The user
changeable parameters in the Switch are as follows:
Bridge Priority.
65535. 0 is equal to the highest Bridge Priority.
Bridge Hello Time.
seconds. This is the interval between two transmissions of
BPDU packets sent by the Root Bridge to tell all other
Switches that it is indeed the Root Bridge. If you set a Hello
Time for your Switch, and it is not the Root Bridge, the set
Hello Time will be used if and when your Switch becomes
the Root Bridge.
Note that the Hello Time cannot be longer than the Max.
Age. Otherwise, a configuration error will occur.
Bridge Max. Age.
seconds. At the end of the Max. Age, if a BPDU has still
30
A Bridge Priority can be from 0 to
The Hello Time can be from 1 to 10
The Max. Age can be from 6 to 40
Switch Management
Advertisement
Table of Contents
