Table of Contents
Advertisement
"password" to control access to the Switch. If the Switch receives
a request with a community name it does not recognize, it will
trigger an authentication trap.
The SNMP allows up to four different community names to be
defined. The community name
can change this name in addition to adding others. You will need
to coordinate these names with the community name settings you
use in your network management system.
The following SNMP Manager Configuration parameters can be
set:
Access Rights:
set to either read only or read/write.
Status: determines whether this SNMP Community name
entry is valid or invalid.
Figure 6-15. SNMP Manager Configuration
Using the Console Interface
10/100 Fast Ethernet Switch User's Guide
public
allows each community to be separately
is defined by default; you
53
Advertisement
Table of Contents
