Table of Contents
Advertisement
BOOTstrap Protocol). You can use the Software Update menu to
control this feature.
The fields you can set in this menu are:
Software Update Determines whether or not the Switch
will try to look for a configuration file over the network. If
set to Disable, none of the fields below have any effect.
Software Update Mode Set to either Network or Out-of-
band. Determines whether the configuration file should be
obtained through the Ethernet network or through the
console port.
Boot
Protocol:
BOOTP&TFTP.
to enabled.
Boot Server IP Address: The IP address of the TFTP
server where the configuration file is located. This entry is
used only if the Software Update is set to enabled and your
boot protocol is
mode, or if Send BOOTP Request on Power Up (see
tftp
TCP/IP Parameters Configuration Menu) is set to "Yes," the
address will be obtained from the BOOTP server.
Boot File Name: The pathname of the configuration file
on your TFTP server. This entry is used only if your boot
protocol is TFTP ONLY; if you are using BOOTP&TFTP
mode, the pathname will be obtained from the BOOTP
server.
Using the Console Interface
10/100 Fast Ethernet Switch User's Guide
Set
to
either
Applies only if the Software Update is set
.
tftp only
TFTP
If you are using
ONLY
or
bootp-
49
Advertisement
Table of Contents
