Diamondback 910Ic Owner's Manual page 12

1
B-19
B-20
4
B-19
G-9
B-1
• Remove the endcap fixing screw (B-20) from the bottom of the
handlebar assembly (B-19), set aside.
• Pull the endcap (B-1) from the bottom of handlebar assembly.
Completely separate the endcap from the console wire (B-17) using
the slot opening and set aside.
• Connect B-17 to wire harness connector G-9, taking care to ensure
the connection is firm.
12
2
B-17
B-1
5
B-19
B-1
• Take the endcap (B-1) from previous step and using the slot
opening, attach it to the G-9 wire exiting the main bike frame.
• Push the wire and connection up into the handlebar assembly
(B-19), followed by the endcap (B-1).
• Reinstall the endcap fixing screw (B-20). Push any remaining G-9
wire slack into the main bike frame (G).
3
B-17
G-9
6
G-9
B-20
G-9
G