Diamondback 910Ic Owner's Manual page 11

B-15
B
B-13
H-6
B-23
H-5
H-4
• Attach handlebar (B) to the underside of the stem assembly (B-19)
with the two (2) stem fixing bolts (H-4), two (2) lock washers (H-5)
and two (2) flat washers (H-6). Make the final angle adjustment
before fixing the bolts firmly.
• Completely Remove stem wire retaining cap (B-25). Insert pulse
wire (B-23) into the stem assembly and feed wire up until it appears
next to the upper wire harness connector. Reinstall retaining cap.
• Attach the water bottle cage assembly (B-15) to the underside of
the stem assembly (B-19) with the three (3) Phillips fixing screws
(B-13). Thread all screws into place loosely before performing final
tightening.
B-13
B-19
B-25
910Ic Owner's Manual
• Remove the four console fixing screws (A-1) from the back of the
console (A) and set them aside.
• Plug the upper wire harness connector (B-17) and pulse wire (B-23)
into the back of the console (A). Make sure the connections are
complete.
• Position the console above the mounting plate located on the top
on the stem assembly (B-19). Reinstall the four (4) fixing screws
(A-1) through the underside of the plate and into the console.
Tighten the four screws only after all four have been started by hand.
A
A-1
A-1
B-17
B-23
11