Diamondback 910Ic Owner's Manual page 10

B-19
B-17
F-L
10
G-16
• Insert the stem assembly (B-19) into the
receiver on the main frame, paying care not
to pinch the wire harness connector (B-17).
L
• Loosen the stem height adjuster knob (G-16)
with two or three counter-clockwise rotations.
Adjust the stem/handlebar assembly to the
lowest position by pulling outward on the
knob to disengage the pop-pin. If the stem
assembly does not drop, loosen the knob
further and pull outward on the knob again.
Repeat these steps again if necessary.
• Tighten adjuster knob (G-16) to lock the
F-R
assembly in the lowest position.
• Install the saddle (L) onto the seat post and
tighten with the included wrench.
• Install the pedals (F-L & F-R) onto the
cranks by threading the left pedal by hand
(marked with an "L") into the left crank with a
counter-clockwise rotation. Do not cross-
thread the cranks/pedals. The pedal must
be tight and installed completely to prevent
future damage to the cranks.
• Repeat the pedal installation steps for the
right side, noting that the pedal will thread
into the right crank with a clockwise rotation.