Final Installation & Setup - Diamondback 910Ic Owner's Manual

FINAL INSTALLATION & SETUP
B-4
G-16
D-2
M-1
B-4
G-6
N
F-16
910Ic Owner's Manual
• Moving and Positioning the Unit. Move the 910Ic into the desired
final position by carefully raising the rear end of the unit until the
wheels located in the front stabilizer contact the floor. Leave room
around the unit for safe operation and sufficient air flow.
• Leveling the Unit. Level the unit by rotating the four leveling
feet located in the stabilizer bars. Lock the feet into position by
tightening the jamb nut upward, against the frame.
• Final Adjustments – Up/Down. Raise and lower the stem and
handlebar assemblies by loosening the adjuster knobs (G-16)
with a couple of counter-clockwise rotations. While supporting
the assembly, pull the knob outward, away from the frame, to
disengage the pop-pin. Raise or lower the assembly as desired,
releasing the knob to reengage the pop pin. Tighten the knob to
lock the assembly in place.
• Final Adjustments – Fore/Aft. Fore-aft adjustment for the seat and
handlebar are made by loosening the levers (B-4) located under
the assemblies. Rotate the lever to the left to loosen. If the lever
movement in inhibited by the frame or other components, pull the
lever downward to reposition the lever and release. Continue to
loosen. Only 1/ 4 turn should be required to loosen or tighten the
levers. Position the seat and handlebar slides and secure the levers.
• Charge the Unit. Plug one end of the power adaptor/charger (N)
into a 120V power source. Plug the opposite end into the power
input jack (F-16) found on the rear end of the plastic housing.
13