Mains Connection - Thermo Scientific Sorvall RC-4 Instruction Manual

• The centrifuge should not be exposed to heat and strong sunlight.
• The set-up location must be well-ventilated at all times.

Mains Connection

Mains Plug
Figure 2-1. Mains Connection
1. Turn off the power supply switch located on right side (press "0").
2. Plug the centrifuge into grounded electrical sockets only.
3. Check whether the cable complies with the safety standards of your country.
4. Make sure that the voltage and frequency correspond to the figures on the rating plate.
5. Establish the connection to the power supply with the connecting cable.
Thermo Scientific
WARNING UV rays reduce the stability of plastics.
Do not subject the centrifuge, rotors and plastic accessories to direct sunlight.
2
Before Use
Mains Connection
2-5
Sorvall RC-4