Chapter 2 Before Use; Before Setting Up; Setting Up - Thermo Scientific Sorvall RC-4 Instruction Manual

2
Before Use

Before Setting up

Before Setting up
1. Check the centrifuge and the packaging for any shipping damage.
Inform the shipping company and Thermo Fisher Scientific immediately, if any damage
is discovered.
2. Remove the packaging.
3. Check the order for completeness (see
If the order is incomplete, please contact Thermo Fisher Scientific.

Setting up

Note The centrifuge is screwed onto the pallet with four screws.
1. Place the pallet with the centrifuge so that you have atleast 2 m room in front of the pallet.
2. Release the rails from the pallet.
3. Screw the rails onto the pallet in front of the centrifuge.
2-2
Sorvall RC-4
WARNING The centrifuge operated with a high kinetic energy. Do not operate the
centrifuge without a 30 cm (12 inch) safety zone around the centrifuge.
Do not operate the centrifuge on its castors.
Screws
Rails
"Scope of Supply" on page iii).
Thermo Scientific