Mounting And Installation; Mounting Positions - Elation Design LED 36UV Manual

Table of Contents

DESIGN LED 36UV™

6. MOUNTING AND INSTALLATION

Cautions:

For added protection mount the fixtures in areas outside walking paths, seating areas, or in

areas were the fixture might be reached by unauthorized personal.

Before mounting the fixture to any surface, make sure that the installation area can hold a

minimum point load of 10 times the device's weight.

Fixture installation must always be secured with a secondary safety attachment, such as an

appropriate safety cable.

Never stand directly below the device when mounting, removing, or servicing the fixture.

Before taking into operation for the first time,

the installation has to be approved by an expert.

When installing the device, make sure there is no highly

inflammable material within a distance of min. 0,5m

Mounting

The Design LED 36UV™ is fully operational in three different mounting positions, hanging

upside-down from a ceiling, side mounted, or set on a flat level surface (see illustration

below). Be sure this fixture is kept at least 0.5m away from any flammable materials

(decoration etc.). When clamp mounting; always use and install the supplied safety cable

as an added safety measure to prevent accidental damage in the event of a clamp failure.

See illustration on next page.

www.ElationLighting.com

Table of Contents