These instructions contain important information regarding safety during use and maintenance. UNPA C K I N G : Thank you for purchasing the DESIGN LED 36WA™ by Elation Professional®. Every DESIGN LED 36WA™ has been thoroughly tested and has been shipped in perfect operating condition.
Please do not discard the shipping carton in the trash. Please recycle whenever possible. WARRANTY REGISTRATION: The DESIGN LED 36WA™ carries a two year (730 days) limited warranty. Please fill out the enclosed warranty card to validate your purchase. All returned service items whether under warranty or not, must be freight pre-paid and accompany a return authorization (R.A.) number.
4. For safe operation, follow the Installation guide described in chapter two of this manual. Operating the Design LED 36WA™ without suited safety aids such as safety cables or clamps can increase the risk of damage and/or personal injury.
0,5m Mounting The Design LED 36WA™ is fully operational in three different mounting positions, hanging upside-down from a ceiling, side mounted, or set on a flat level surface (see illustration below). Be sure this fixture is kept at least 0.5m away from any flammable materials (decoration etc.).
DESIGN LED 36WA™ fixture. See illustration on next page. Securing the Design LED 36WA™ Regardless of the rigging option you choose for your Design LED 36WA™ always be sure to secure your fixture with a safety cable. The fixture provides a built-in rigging point for a safety cable on the hanging bracket as illustrated above.
2 and 3 of a male XLR connector (DATA + and DATA -). This fixture is inserted in the female XLR connector of the last fixture in your daisy chain to terminate the line. Using a cable terminator (Elation part number Z-DMX/T) will decrease the possibilities of erratic behavior.
Page 18
DESIGN LED 36WA™ fixture. In the case of the Design LED 36WA™, which is a 5 channel fixture (default – optional 2 channel), you should set the starting DMX address of the first unit to 1, the second unit to 6 (5 + 1), the third unit to 11 (5 + 6), and so on. Use the chart on page 22 to quickly reference the proper DMX dipswitch combination for address 1~512.
DESIGN LED 36WA™ 8. OPERATING MODES NOTE: The Design LED 36WA contains a total of 12 dipswitches. Only use dipswitches 1~9 to set the DMX address. Dipswitches 10~12 are used for special functions that are explained below. Dipswitch 12: Mode Selection - When in the “OFF” position the fixture functions in default mode, which is 3 DMX channels.
There are no user serviceable parts inside this fixture with the exception of the lamp. Please refer all other service issues to an authorized Elation service technician. Should you need any spare parts, please order genuine parts from your local dealer.
® defective parts at its expense, and will absorb all expenses for warranty service and repair labor by reason of defects in material or workmanship. The sole responsibility of Elation Professional under this warranty shall be limited to the repair of the product, or ®...
Page 26
The consumer’s and or Dealer’s sole remedy shall be such repair or replacement as is expressly provided above; and under no circumstances shall Elation Professional® be liable for any loss or damage, direct or consequential, arising out of the use of, or inability to use, this product.