Elation Design LED 36UV Manual page 11

DESIGN LED 36UV™
hung, mounted, or stood straight up.
4. Diffusion Lens – This lens is used to both protect the LEDs as well a diffuse the light
output.
5. LED Assembly – 36 1-watt LEDs construct the LED assembly.
6. Power Cord – Provides main power to the unit.
7. On/Off Power Switch – Controls main power to the unit.
8. DMX In Jack – This jack accepts an incoming DMX signal via a male, 3-pin XLR jack.
9. DMX Out Jack – This jack is used to send an incoming DMX signal to the next fixture in
the DMX chain via a female, 3-pin XLR jack.
10. Fuse Holder Housing – This housing holds the GMA (2) amp protective fuse. Never
use a fuse greater than that specified by the manufacture. Using a fuse other than that
specified could seriously damage the unit and will void your manufactures warranty.
11. Dipswitch Assembly – These dipswitches are used to set the DMX address,
master–slave settings, and other special functions. See the dipswitch chart on page 16 for
more information on the dipswitch functions.
©Elation Professional, Los Angeles Ca. 10 www.ElationLighting.com