Transmitter / Transceiver Programming - CrimeStopper EZEE Start EZ-45DP Installation Instructions Manual

Transmitter Programming:
Notes: Remote Transmitters/Transceivers come pre-programmed from the Factory. When re-learning remotes or adding
remotes, ALL your system's remote codes must be learned at time of programming!! These systems allow storage of up
to 4 different remote codes in memory. The "Sidekick" transmitters for the TW1/TW2 and FM systems are a special model
that is not compatible with each other.
1. Open hood (ground the Blue hood pin wire if no hood pin is installed.)
2. Turn key to the ON position. (Do not start vehicle) Pink wire must be connected!
3. Press Program/Valet button 4 times. Wait for the unit to flash the parking lights and/or honk horn exactly 4 times.
4. 1-Way systems: Press Button #1 (Lock) of the transmitter to be learned. 2-Way systems: Both the Lock & Unlock
buttons must be pressed. You should get 2 light flashes and 2 horn honks indicating the code-learn. Now the unit is
nd
waiting for a 2 code, so repeat this step as needed with up to 3 additional remotes. The unit will flash the lights in
succession after each code learned for up to 4 codes. (3 flashes for the 2
code.) If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key OFF and close
the hood.
(BLUE WIRE GROUNDED)
1-WAY SYSTEMS
PRESS
LOCK ONLY
TRANSMITTER PROGRAMMING
IGN
OFF
2-WAY SYSTEMS
& "SideKick" REMOTES
LOCK &
UNLOCK
PRESS TOGETHER
26
nd
code, 4 flashes for the 3
PRESS 4X's
OFF
FLASH 2, 3, or 4 X's
rd
code and 0 for 4
WAIT FOR
4 FLASHES
IGN
COMPLETE
th