Wiring Wiring High-Current Connector - CrimeStopper EZEE Start EZ-45DP Installation Instructions Manual

PIN 1: GREEN/RED: (-) AUX#1 OUTPUT (TRUNK POP) or DOME LIGHT ILLUMINATION OUTPUT
This output is programmable for two modes of operation. See Programming Option Section.
Mode (1) DEFAULTS: Provides a Ground pulse when button #3 (Trunk) on the remote transmitter is pushed to activate
a factory electric trunk release or other optional accessory.
Mode (2) ALTERNATE: Provides a Ground output for 30 seconds when the unlock button is pressed for use as a dome
light illumination output.
Note when using the GREEN/RED wire as a Trunk Pop, you may also need or want to program option #14 so the
system also provides an Unlock signal when the trunk pop is activated. This may help to prevent unnecessary
triggering of Factory Alarm systems or you may want the convenience of having the door unlock at the same time.
GREEN/RED WIRE: TRUNK OUTPUT or DOME LIGHT
GREEN/RED
Trunk Soleniod
(Default)
-OR-
Dome Light
Circuit
PIN 2: BLUE/BLACK: (-) AUX#2 OUTPUT
Provides a Ground pulse when button #5 (Star button) is pressed, then press button #1 (Lock) within 2 seconds on
the remote transmitter. The LED flashes orange when the Star button is pressed (2
WIRING
+12V CONSTANT
85
86
30 87
+12V CONSTANT
* Test activation circuit in vehicle.
Connect to+12V for Positive circuits
or Ground for Negative circuits. Relay
not included.
9
OR *
nd
function mode).