Transmitter / Transceiver Programming - CrimeStopper Cool Start RS-7 Installation Instructions Manual

Transmitter Programming: (Excludes RS-00 model without remotes)
Notes: Remote Transmitters/Transceivers come pre-programmed from the Factory. When re-learning remotes or adding
remotes, ALL your system's remote codes must be learned at time of programming!! These systems allow storage of up
to 4 different remote codes in memory.
1. Turn key to the ON position. (Do not start vehicle) Pink wire must be connected!
2. Press Program/Valet button 4 times. Wait for the unit to flash the parking lights and/or honk horn exactly 4 times.
3. Press Lock Button #1 of the transmitter to be learned. You should get 2 light flashes and 2 horn honks indicating the
code has been learned. Now the unit is waiting for a 2
remotes. The unit will flash the lights in succession after each code learned for up to 4 codes. (3 flashes after the 2
code, 4 flashes after the 3
learning mode, otherwise turn key OFF.
OFF
PRESS LOCK
TRANSMITTER PROGRAMMING
rd th
code and 0 for 4 code.) If all 4 codes are learned, the unit will automatically exit code
IGN
PRESS 4X's
FLASH 2, 3, or 4 X's
nd
code, so repeat this step as needed with up to 3 additional
OFF
21
WAIT FOR
4 FLASHES
IGN
COMPLETE
nd