CrimeStopper EZEE Start EZ-45DP Installation Instructions Manual page 12

PIN 5:YELLOW/BLACK: FOR ANTI-GRIND/STARTER DISABLE OUTPUT: (Relay not included)
TO
MOTOR
PIN 6: BLUE/WHITE: (-) STARTER #3
This wire provides a ground output for vehicle that requires a third starter wire to remote start.
PIN 7: ORANGE: (-) OEM REARM OUTPUT
This wire provides a ground pulse to rearm the vehicles' FACTORY anti-theft system after a timed-out or aborted remote
start. Connect this wire to the vehicles' anti-theft rearm wire or to the door pin circuit depending on your requirements.
This wire may be needed to pulse the door pin circuit on vehicles with retained accessory power.
PIN 8: ORANGE/BLACK: (-) OEM DISARM OUTPUT
This wire provides a Ground pulse to disarm the vehicles' Factory anti-theft system prior to a Remote Start. Connect this
wire to the vehicles' anti-theft disarm wire. This wire is sometimes found coming off the Driver's door key switch or at the
Factory Anti-theft control module. This wire may not be needed if Factory Security only requires a door unlock pulse.
WIRING Cont.
IGN 1
IGN 2
ACC
START
BROWN
YELLOW/BLACK
MAKE CERTAIN TO CONNECT "BROWN" START OUTPUT WIRE TO
MOTOR SIDE OF ANTI-GRIND/START DISABLE RELAY.
MAKE SURE 86 TERMINAL HAS POWER WITH IGNITION ON AND CRANK
CUT
85 86
12