CrimeStopper EZEE Start EZ-45DP Installation Instructions Manual page 20

To Engage Option Programming:
1. Open hood (If no hood pin switch is installed, then ground the Blue wire)
2. Turn Key to the ON position. (Do not start vehicle) Pink wire must be connected!
3. Press the program / valet button 5 times. Wait for the unit to flash the lights and/or horn honk 5 times.
4. Push the valet/program button the number of times that corresponds to the option number desired (1-22X). You
must get a light flash and/or honk after each button press. If the system did not flash the lights and/or honk,
then it did not register your press. Press carefully and do not lose count.
5. When you reach the desired option #, Press button #1(Lock) or #2 (Unlock) to change the option. (Some
option numbers use ALL 4 remote buttons to select settings)
6. When finished, turn Ignition OFF, close hood (or un-ground Blue wire) and check for changed features.
Option
Option Description
Number
1 Engine Monitoring
2 Auto Lock with RPM/Ignition
3 Door Lock Pulse Time
4 Double Unlock Pulse
5 OEM Interface Green input wire
Double button press for
6
Remote Start and Trunk pop
7 Horn Chirps on Remote Start
8 Lock After Remote Start/Abort
9 Green/red wire function
"Wake Up" pulse on Unlock
10
(1-sec. +12V to IGN)
11 N/A - Not used
OPTIONS PROGRAMMING Cont.
OPTION PROGRAMMING TABLE
TX Button #1
Learn Tach
OFF
3 Sec.
2 Pulse
3 Pulse
ON
ON
OFF
Dome Light
ON
20
TX Button #2 TX Button #3
*Tachless*
*ON*
*0.75 Sec.*
*1 Pulse*
*1 Pulse*
*OFF*
*OFF*
*ON*
*Trunk pop*
*OFF*
TX Button #4