Crestron Isys TPS-5000 Operation Manual page 43

Crestron Isys™ TPS-5000
Operations Guide - DOC. 5863A
3. As shown after this step, select the Net ID of the TPS-5000 touchpanel and
then click OK. The "Touch Panel Transfer" window appears (refer to the
subsequent graphic).
"Select Network ID" Window
NOTE: If problems occur when transferring any Cresnet file (touchpanel
project/firmware), lower the port speed baud rate to 38400 to match the Cresnet bus
speed when transferring through a control system.
"Touch Panel Transfer" Window
Additional choices include Do not send graphic files and Do not send sound files.
These are often very large files that take a long time to load.
4. Click Browse. The "Open" window appears as shown in the following
illustration.
12 Inch Tilt Touchpanel: Crestron Isys™ TPS-5000 • 39
12 Inch Tilt Touchpanel
Check Send Direct to Wired Touchpanel if
connected via RS-232 directly to touchpanel.
Each time a project is selected using
the Browse command, that project is
added to the File Name drop-down
list. This makes it convenient to
recall projects without need to
browse to a directory. To delete the
list click Clear History.
All Files in Project: sends the entire
project.
Only Changed Files: sends only the
files that are different from those that
are currently stored in the panel.
Note that if any pages in the panel
are not present in the project, those
pages will be deleted from the panel.