Crestron Isys TPS-5000 Operation Manual page 23

Crestron Isys™ TPS-5000
Operations Guide - DOC. 5863A
Hardware Connections for the TPS-5000
AUDIO:
STEREO AUDIO INPUT
& MIC OUTPUT VIA
TPS-IMPC
HEADPHONES
HEADPHONES:
TO EXTERNAL
HEADPHONE
SET
HEADPHONES
Connect this standard mini phone jack (12mW, 32 ohms load) to the plug of an
external headphone set, not supplied.
AUDIO
This 8-pin, RJ-45 connector mates to an interface module with a supplied cable and
provides differential/single ended audio input and output. It also produces line level
differential output. Description of the pinouts is shown in the following table.
AUDIO Pinouts
TYPE
8
1
Top
Front
8
1
To determine the location of pin 1, hold the supplied cable so that the end of the
8-pin RJ45 connector is facing away from you, with the clip side down and the
copper side up. The copper contact on the far left is pin 1.
NOTE: When connecting the touchpanel to the interface module, do not confuse the
8-pin audio cable with the 10-pin net/video cable.
RS-232
This 6-pin RJ-11 connector mates with a serial port of a PC. The connecting cable is
not supplied. Prior to installation, use this port for direct connection between the
12 Inch Tilt Touchpanel: Crestron Isys™ TPS-5000 • 19
12 Inch Tilt Touchpanel
RGB:
RGB VIDEO
INPUT
AUDIO RS-232 RGB NET/VIDEO
NET/VIDEO:
RS-232:
TO CRESNET VIA
TO PC OR
TPS-IMPC / INPUTS
ANY RS-232
COMPOSITE OR
DEVICE
S-VIDEO
PIN DESIGNATION
1 L+
2 L-
3 GND/Shield
4 R+
5 R-
6 GND/Shield
7 M+
8 M-
ETHERNET:
10/100 BASE-T
ETHERNET TO
LAN OR WEB
LAN 24VDC 2.0A
POWER:
TO POWER PACK
(24VDC, 2A OUTPUT)
DESCRIPTION
Left Input (Positive)
Left Input (Negative)
Audio Input Ground/Shield
Right Input (Positive)
Right Input (Negative)
Mic Output Ground/Shield
Mic Output (Positive)
Mic Output (Negative)