Crestron Isys TPS-5000 Operation Manual page 40

12 Inch Tilt Touchpanel
36 • 12 Inch Tilt Touchpanel: Crestron Isys™ TPS-5000
Setup | Communications Settings Command
3. Select RS-232 as the connection type. Verify that an available COM port
(COM 1 is shown after this step) is selected, and that all communication
parameters and necessary options from the "Port Settings" window are
selected as shown after this step. Click the OK button to save the settings
and close the window.
"Port Settings" Window
NOTE: The parameters shown in the previous illustration are the port settings for a
2-Series control system. Consult the Operations Guide for the control system being
used for exact parameter selection.
NOTE: If connecting to the touchpanel through a control system, the baud rate may
need to be set to 38400 baud (Cresnet speed) for a successful transfer.
Crestron Isys™ TPS-5000
Operations Guide - DOC. 5863A