Crestron Isys TPS-5000 Operation Manual page 39

Crestron Isys™ TPS-5000
Operations Guide - DOC. 5863A
Typical Connection Diagram when Uploading a Project
To prepare the TPS-5000 for uploading or upgrading directly from a PC, refer to the
following figure. Connect the RS-232 port of the computer directly to the RS-232
port of the touchpanel. Refer to page 19 for RS-232 cable information.
NOTE: Directly connecting to the touchpanel over RS-232 provides a faster
transmission speed than Cresnet.
Typical Connection Diagram when Uploading a Project Directly to the Touchpanel
NOTE: For cable pinouts, refer to "RS-232" on page 19.
1. Open the Crestron Viewport.
Either launch the stand-alone version of Viewport, or start SIMPL
Windows, and from the menu bar, select Tools | Viewport.
2. Refer to the following figure. From the Viewport menu, select Setup |
Communications settings (alternatively, press Alt+D) to open the "Port
Settings" window.
12 Inch Tilt Touchpanel: Crestron Isys™ TPS-5000 • 35
12 Inch Tilt Touchpanel