Hardware Hookup - Crestron Isys TPS-5000 Operation Manual

12 Inch Tilt Touchpanel
DIAGNOSTICS MENU
18 • 12 Inch Tilt Touchpanel: Crestron Isys™ TPS-5000
appropriate inputs on the TPS-IMPC. Refer to the latest version of the TPS-IMPC
Interface Module Operations Guide (Doc. 6162) for details.
NOTE: A solid blue screen is displayed in the video window if a video signal is not
detected or is very weak. Verify that the video source is functioning and properly
connected. If the source is properly connected and functioning, a distribution
amplifier may need to be used.
Fast motion mode (if the Fast Motion button is selected) reduces motion artifacts
and should be used for most video sources. Still video mode (if the Still Video
button is selected) works best for still pictures. It has a maximum resolution and
reduces flicker. However, it suffers from motion artifacts. The text color of the
selected button is red rather than black.
Select the Soft button for soft mode video. In this mode, video filtering and noise
reduction can produce a better image from some sources. Alternatively, select the
Sharp button for sharp mode video. This mode provides maximum detail, but is
more susceptible to noise in source. The text color of the selected button is red rather
than black.
Select the Return button, located at the lower right corner of the Video Menu, after
video parameters have been set.
Diagnostics Menu
The Diagnostics button from the MAIN MENU contains controls for enabling an
Ethernet card (if installed) and diagnostic tools. The diagnostic tools should only be
used under supervision from a Crestron customer service representative during
telephone support. The options available from the DIAGNOSTICS MENU, shown
to the left, are numeric in nature and their interpretation is beyond the scope of this
manual.
NOTE: If the Disable Ethernet button is selected, the touchpanel will not
communicate via TCP/IP or Cresnet Internet Protocol (CIP). Select "Enable
Ethernet" to enable the Ethernet card. For more information, refer to "Interface
Menu" on page 12.
NOTE: The "About..." button will display a screen indicating the current version
of firmware residing on the touchpanel.

Hardware Hookup

Make the necessary connections as called out in the following illustration. Refer to
"Network Wiring" on page 9 before attaching the NET or NET/VIDEO connector.
Apply power after all connections have been made.
CAUTION: Do not apply excessive pressure to the touchscreen display during
handling. Doing so can crack the screen and damage the touchpanel.
NOTE: Not all ports are active; some require the additional purchase and
installation of an expansion card to enable operation.
Crestron Isys™ TPS-5000
Operations Guide - DOC. 5863A