Uploading A Simpl Windows Program - Crestron TPS-2000L Operation Manual

5 Inch Lectern/Wall Mount Touchpanel
A control system source file has
the extension .smw. A compiled
SIMPL Windows file has the
extension .spz for a 2-Series
control system, .bin for CNX
generation, and .csz for CNX
generation with SIMPL+.
32 • 5 Inch Lectern/Wall Mount Touchpanel: TPS-2000L
NOTE: Control system communications can be verified by selecting Diagnostics |
Establish Communications (Find Rack). This should display a window that gives
the COM port and baud rate. If communication cannot be established, refer to the
"Troubleshooting Communications" section in the respective Operations Guide for
the control system.

Uploading a SIMPL Windows Program

The SIMPL Windows file can be uploaded to the control using SIMPL Windows or
via the Crestron Viewport.
Upload via SIMPL Windows
1. Start SIMPL Windows.
2. Select File | Open to view the "Open" window, navigate to the SIMPL
Window file (.smw), and click Open.
3. Select Project | Transfer Program.
Upload via Crestron Viewport
1. Verify that the procedure for "Communication Settings" that begins
on page 30 has been performed.
2. As shown after this step, select File Transfer | Send Program
(alternatively, press Alt+P) from the Viewport menu.
File Transfer | Send Program Command
3. The "Send Program" window appears, as shown after this step. Click
Browse, locate the compiled file (.spz) and click Open. This will
display the program's header information and enable one or both of
the What to Send check boxes. If the program does not contain any
SIMPL+ modules, only the SIMPL Program check box will be
enabled. If it does contain SIMPL+ modules, then the SIMPL+ check
box will also be enabled. Select one or both check boxes and then
click Send Program to begin the transfer.
NOTE: Refer to the respective Operations Guide for the control system for details
about the other fields shown on the "Send Program" window.

Crestron Isys TPS-2000L
Operations Guide – DOC. 5972A