Lbb4410/00 Network Splitter; Introduction; Controls, Connectors And Indicators - Bosch DCN Next Generation Installation And User Instructions Manual

DCN NG | Installation and User Instructions | Section 4 | Installation Accessories
18 LBB4410/00 Network
Splitter
18. 1

Introduction

The LBB4410/00 Network Splitter is used to create
short-circuit proof tap-off points in the optical network.
18.2 Controls, connectors and
indicators
18.2.1 Exterior
The exterior of network splitter (see figure 18.1)
contains the following:
1 External power supply - A socket for an
(optional) external power supply. The external power
supply only feeds the tap-offs. It does not provide
power to the trunk line (see section 18.3.3).
2 Tap-off 1 - An optical network socket to create a
tap-off. The tap-off is protected for short-circuits and
has a maximum load of 2.5 A (see sections 18.2.2
and 18.3.2).
3 Trunk - An optical network socket to connect the
network splitter to the optical network (see
section 18.3.2).
4 Lid - A lid that provides access to the jumpers (see
section 18.2.2). The rear side of the lid contains a
label with explanation about the internal settings (see
figure 18.3).
5 Status LED - A yellow status LED that provides
information about the status of the network splitter
(see section 18.5).
6 Status LED - A green status LED that provides
information about the status of the network splitter
(see section 18.5).
7 Tap-off 2 - An optical network socket to create a
tap-off. The tap-off is protected for short-circuits and
has a maximum load of 2.5 A (see sections 18.2.2
and 18.3.2).
8 Trunk - An optical network socket to connect the
network splitter to the optical network (see
section 18.3.2).
Bosch Security Systems | 2004-03 | 9922 141 70521en
1 2
7
figure 18. 1 : Exterior of the network splitter
en | 109
3
4
5
6
8