Club Car V-GLIDE Maintenance Service Supplement page 96

16B
TRANSAXLE (TYPE K)
Transaxle Removal, Continued:
2. Place a floor jack under the transaxle and raise the rear of the vehicle. Position jack stands under the
frame crossmember between the spring mount and the side stringer, just forward of each rear wheel.
Lower the vehicle to let the jack stands support the vehicle (Figure 16b-7, Page 16b-6).
3. Remove the rear wheels, then thread one lug nut onto a stud on each rear hub. This will keep the brake
drums on the hubs.
4. Remove the bow-tie pins (1), brake cable clevis pins (2), and cable retaining E-clips (3). Disconnect the
brake cables (4) (Figure 16b-8, Page 16b-6).
Figure 16b-7 Vehicle Supported on Jack Stands
5. Disconnect the shock absorbers from their lower mounts (Figure 16b-9, Page 16b-6).
6. Disconnect the four motor wires. Use two wrenches to prevent the post from turning.
7. With a floor jack supporting the transaxle, remove lower spring shackle nuts and bolts. Position shackles
so they are clear of springs (Figure 16b-10, Page 16b-6).
Figure 16b-9 Disconnect Shocks
Page 16b-6 2004 V-Glide 36-Volt Electric Vehicle Maintenance and Service Supplement
3
Figure 16b-8 Disconnect Brakes
Remove bolts, then
rotate shackles
up and away
from spring.
Figure 16b-10 Shackles
Transaxle
2
4
1